Page 1 of 1
White cloud or glare over tables
Posted:
Sun Sep 05, 2010 3:16 pmby Zjak
Hello,
For the last couple of days, I have been running into an issue where my FTP tables get a white film or glare over them when pt3 is getting ready to put the stats or refresh stats on that table. It only lasts a couple of seconds but is very annoying.
I can send a screenshot is needed.
Best regards
Re: White cloud or glare over tables
Posted:
Sun Sep 05, 2010 3:22 pmby kraada
Do you use Logitech Set Point? That sounds like a known bug with old versions of Set Point - updating Set Point (if that's the cause for you) will fix this issue.
Re: White cloud or glare over tables
Posted:
Sun Sep 05, 2010 3:24 pmby Zjak
yes i do, will update. Tnx for the amazingly quick reply.
Re: White cloud or glare over tables
Posted:
Sun Sep 05, 2010 3:26 pmby kraada
You're welcome
Re: White cloud or glare over tables
Posted:
Wed Sep 08, 2010 1:42 pmby Zjak
Well, I updated my setpoint and it still does it. I can get by for now by disabling setpoint but it's a workaround and not a solution of course. Any other ideas of how to change settings within setpoint or so?
Re: White cloud or glare over tables
Posted:
Wed Sep 08, 2010 3:25 pmby kraada
Are you using the Aero theme?
Re: White cloud or glare over tables
Posted:
Thu Sep 09, 2010 11:39 pmby Zjak
not anymore, will see if that solves it.
pardon my laziness if this bug has been discussed a lot
Re: White cloud or glare over tables
Posted:
Fri Sep 10, 2010 4:01 amby WhiteRider
Every time we've seen this reported it has been caused by SetPoint, and I've had several people confirm that updating to the latest version has fixed it.
