PokerTracker

I am trying to make a filter for all hands that I Cbet with for over card/s, no overcards, or low pair on the flop. I want to find out if I am making money when cbetting.

On the filter, I checked the following:

I selected a site and limit to start. (To minimize the size until I know I had it right.)
I checked all hole cards, although I assume you could leave them all unchecked.

Under hand values advanced, I selected High Card on Flop: Overcards, one overcard and no overcards
Also selected one pair on flop, low pr

Preflop stats tab i selected any pf raise

on flop stats tab i selected after preflop raise - bet

It returns 64 hands under the general tab: players statistics

When I go to the Hands tab, none of the hands show. It doesnt matter if i select by starting hands or final hands

Is this functionality available yet or is it a bug? I would like to be able to see the hands for this filter.

[quote="Oakrdrzfan"173]Under hand values advanced, I selected High Card on Flop: Overcards, one overcard and no overcards
Also selected one pair on flop, low pr[/quote173]
Are you applying both of these filter options together?
I believe that at the moment all filters are applied with an AND, so you would have to have 'high card on flop' AND 'one pair on flop' at the same time, which is not possible.

[quote="Oakrdrzfan"173]It returns 64 hands under the general tab: players statistics

When I go to the Hands tab, none of the hands show. It doesnt matter if i select by starting hands or final hands[/quote173]
I'm not sure about this, but I believe that the player statistics don't react to [all of] the filters, so you may still see stats there that filtered out.

Yes, you don't want to select filters that will cancel each other out (like overcards and one overcard). I will be adding the ability to "OR" filters to get the effect you want, but for now you have to avoid this.

You don't have to select all the hole cards. You can leave them blank and it defaults to all.

Ok. Thanks for the reply. Anxiously awaiting the 'or' abilities. I will try and run the filter again with this information.