PokerTracker

Is there a way to filter hands for players by the amount of players at the tables? I.E. if a player is seated on a 9max table and a 6max table the HUD will show the stats for each table respectively, in addition if I start a table with a player and play 50 hands of heads-up is there a way to filter this out within the session? Thanks.

Neill

You can set this up via Hud -> Edit Hud Options in the Number of Players Filtered area. PT4 goes down the list that you create there and the first grouping that matches is the stats you get. So if you had 7 to 10, 5 to 6, 4 to 5, 3 to 3 and 2 to 2 then if you were 7-10 handed you'd get 7-10 handed stats at 5 or 6 handed you'd get 5 and 6 handed stats. At 4 handed you get 4 or 5 handed stats, at 3 handed you get 3 handed stats and at 2 handed you get heads up stats only. You can configure it however you like just remember the first group that PT4 runs into going down the list with the number of players at the table is the group that gets displayed.

I see what you're talking about but I feel like I'm not getting how to set it up in a list format so that PT4 recognizes to switch mid session.

Then tell me what you want it to do and I'll tell you how to set it up

Ok, so I have 1600 hands on a player, 1400 are from 6max, 150 are from 9max, and 50 are from HU on a 9max table.

I want the HUD to filter and show 150 when we are sitting at a full 9handed table, show 1400 when we are sitting at a full 6 max table, and show 50 when we start a new table before any other players join. Also if I sit at a 9max table that is shorthanded, when the table gets to 7 handed I would like the HUD to show only hands 7 handed+ for all players. This is a pic of my attempt to set it up this way.

http://i1076.photobucket.com/albums/w44 ... /setup.png

You're in the wrong section of that window. Select "General Settings" at the top, and you will see the "number of players filtered" option that kraada referred to.
For more information click the grey monitory icon in the bottom left corner and choose General Settings to watch the tutorial video.

Got it thanks WhiteRider.

Took me forever but i finally found my answer in THIS post. Thanks!