ATTN users trying connect PT3 across Network
Posted: Tue May 20, 2008 2:51 pmThere is a key piece of information missing in the networking FAQ.
In addition to changing your pg_hba.conf, you also need to change the postgresql.conf file.
Add the following line:
listen_addresses = '*'
And then make sure you stop and start the PostgreSQL service (just reloading the config is not enough).
This information should also be added to the FAQ.
In addition to changing your pg_hba.conf, you also need to change the postgresql.conf file.
Add the following line:
listen_addresses = '*'
And then make sure you stop and start the PostgreSQL service (just reloading the config is not enough).
This information should also be added to the FAQ.
