Page 1 of 2

HUD not working in FT matrix

PostPosted: Sat Jun 01, 2013 10:12 am
by Noen
Got no help for this in the support service. Sent log as advised. Got a list of suggested solutions, among them that I might need to upgrade postgresql. But the link was dead/not functioning. When I asked support to give altermative links, I got no answer ... it is a couple of weeks ago ...
PT imports hands normally, but no HUD appears. Can anyone help?

Regards,

Re: HUD not working in FT matrix

PostPosted: Sat Jun 01, 2013 12:49 pm
by kraada
The link given (this one) works fine for me - what happens when you right click that link and try to save the file?

Re: HUD not working in FT matrix

PostPosted: Sun Jun 02, 2013 2:31 pm
by Noen
YEs, this link worked, and I had it installed, BUT NOW PT 4 is not working ("unable to connect to database") ... Password: dbpass? So I am even worse off ...

Re: HUD not working in FT matrix

PostPosted: Sun Jun 02, 2013 2:56 pm
by Noen
.. and when I choose "continue anyway", I get "error connecting to the default database". And when I try to create a new one, I get "unable to create". Did it all go wrong?

Re: HUD not working in FT matrix

PostPosted: Sun Jun 02, 2013 3:58 pm
by Noen
Tried to reinstall. Do I select "install as a service"?

Re: HUD not working in FT matrix

PostPosted: Sun Jun 02, 2013 7:32 pm
by Noen
Same problem after reinstall ...

Re: HUD not working in FT matrix

PostPosted: Mon Jun 03, 2013 3:28 am
by WhiteRider
That sounds like a problem with the PostgreSQL service. Click Start and type 'services.msc' and open the Services window.
Do you see PostgreSQL in the list?
Is it started?
Can you start it?

If it is there but won't start check our Firewall Guide guide as security software can prevent PostgreSQL running correctly.

Otherwise, follow the appropriate guide here to fully uninstall and reinstall PostgreSQL.

Re: HUD not working in FT matrix

PostPosted: Mon Jun 03, 2013 12:39 pm
by Noen
Thx for reply! No it is not on the list. How do I start it?

Re: HUD not working in FT matrix

PostPosted: Mon Jun 03, 2013 12:55 pm
by Noen
I had version 9.2 and saw that it is not supported for service. When I try to reinstall v 8.3 instead, password (dbpass, postgrespass) are not accepted. What is the correct password?

Re: HUD not working in FT matrix

PostPosted: Mon Jun 03, 2013 12:58 pm
by Noen
And should I mark "install as a service?"