How can I make NoteTracker to be more specific...

[dutch81]

w/ a hand that went to showdown.

I'd really like to have it note that AKs called off X BB's and QQ shoved X BB total or at least have it to where the relative stack sizes are more specific than these screenshots.


They both had 5K to start and blinds were 15/30, so if the above is not possible, how can I create a note to let's say... note any hands where 150BB or more went in PF either by calling off or shoving? Or is that too general? I've been trying to get this to work but can't. I'll post a screenshot of what I thought would work next.

Thank you.

[kraada]

You should definitely be able to pick the differences between raising all in and calling an all in raise. And you can certainly make a note for total amount that went in the pot; those filters are in Hand Details -> Pot Size & Stack Depth.

[dutch81]

So, I expected this filter to note anytime a player gets it in w/ 100-200BB after a raise and 3bet+ PF when BOTH players have at least 100-200BB.

[WhiteRider]

The Player filter only applies to the player that the note is being taken on, not any opponents.
If you want to limit the opponent's stack as well then you'll either need to add an Opponent filter or use the "effective" stack stack size instead of actual stack size. Using an Opponent filter will allow you to be more specific, though.

Other than that your filters look OK, although it will only count hands where the player at least 3Bet preflop - is that what you want?
Are you having a problem with the hands noted?

[dutch81]

So I should add the 100-200x depth filter to the opponent filter as well, not effective BBs to be more accurate?

Yes, if it notes all 3bet+ pots w/ 100-200x, I'm fine with it. I guess I can make a 100-200x non-3bet filter afterwards. I think that would be less complicated.

[dutch81]

You should definitely be able to pick the differences between raising all in and calling an all in raise. And you can certainly make a note for total amount that went in the pot; those filters are in Hand Details -> Pot Size & Stack Depth.

I'm sorry... not sure I follow but, do you mean that I should make 2 filters? One for a 100-200x shove range and one for a calling range?

[WhiteRider]

So I should add the 100-200x depth filter to the opponent filter as well, not effective BBs to be more accurate?

Yes, if it notes all 3bet+ pots w/ 100-200x, I'm fine with it. I guess I can make a 100-200x non-3bet filter afterwards. I think that would be less complicated.

If you want to ensure that the opponent that was involved in the large pot along with the player you're taking the note on met the same criteria then you need to add an Opponent filter as well.

You should definitely be able to pick the differences between raising all in and calling an all in raise. And you can certainly make a note for total amount that went in the pot; those filters are in Hand Details -> Pot Size & Stack Depth.

I'm sorry... not sure I follow but, do you mean that I should make 2 filters? One for a 100-200x shove range and one for a calling range?

That depends on what notes you want to see. If you want different notes for shoving and calling then you need separate note definitions - if you want to see them all in the same note then you only want one note definition with filters which match either case.

[dutch81]

Yes, I want to ensure that both players met the criteria.
Basically in the HH posted before, I want to know anytime someone shoves 100-200 BBs PF when a 3bet or higher is involve and for that range to be noted when reaching showdown.

I ended up deleting that 100-200x Shove Range filter yesterday after it didn't work and I am trying to re-create it but I can't seem to find the "Total Put in pot BBs between 100-200 filter".

I found the "Pot size BBs between 100-200" filter, but that's not what I want, right?

Once I find this, I just duplicate these filters to the Opponent's filters, save and set active and I'm good to go?
Or do I have to make slightly different filters for the opponent?

[WhiteRider]

The "total put in pot" filters are in Hand Details > Amount Contributed to Pot.

Don't set the opponent filter to exactly the same or you will exclude some hands you want to include - just add the filters that are relevant. If you require the opponent to have also 3bet or higher then you'll exclude pots where the opponent 2bet and the player 3bet, for example.

[dutch81]

I only see BB contribution and chip contribution here, no "Total put in pot".