Entering specific boards manually

[Newverynew]

Hi,

I want to make a note (it could also be a stat) that shows when a player is cbetting on a dry Ace high board (for Omaha). I want to enter the boards in question manually. I tried using the simple board filter enabling "exactly one broadway, middle and low card and at least one Ace" AND NOT "any connectedness". I am not sure what any connectedness means exactly: is it at max two gaps or three gaps? I am ok with three gaps but two gaps would be too connected.

Can you give me a hint, please. Can you use A92 with a flush draw and A84 rainbow as an example, if it is possible to enter boards manually.

[kraada]

If you're willing to specify the board cards entirely you can use the Board Cards section with "board contains at least one" - and just ticking each board set. That is, if you tick A, 8, 4 there and Add to Filter that will give you exactly flops that are A84 (in any order). You can the use OR and combine a series of these together. If you have a very specific set of boards in mind that's probably going to work better than trying to make your logic work with ours in terms of connectedness.

[Newverynew]

Thx a lot. I will try this.