Page 1 of 1

Zoom HUD via Parallels?

PostPosted: Mon Nov 17, 2014 7:15 am
by TheST1G
I realise that a Zoom HUD doesn't work via OSX PT4 & Stars Mac Client, but if I use Windows via Parallels and install and run the Windows Stars client, will my existing PT4 work and will a Zoom HUD appear using this combo?

Or, do I have to install both Windows Stars client and Windows PT4 under Parallels? If this is the case, do I have to pay for another Windows PT4 licence?

I really don't care that I may have separate databases, as I would only play via Parrallels for Zoom games.

Thanks.

Re: Zoom HUD via Parallels?

PostPosted: Mon Nov 17, 2014 10:50 am
by kraada
You'll need PT4 on the Windows side as well. Each PT4 code is valid for use on up to two machines that you own and operate though so you won't need to make an additional purchase.

Re: Zoom HUD via Parallels?

PostPosted: Mon Nov 17, 2014 11:26 am
by TheST1G
Thanks. Am I right in my assumption that I'll have two separate databases, one in OSX PT4 and one in Windows PT4?

Re: Zoom HUD via Parallels?

PostPosted: Mon Nov 17, 2014 11:38 am
by kraada
You can do it that way or you can configure PostgreSQL to allow connections from the Windows side it's up to you. For more on how to configure PostgreSQL to allow connections over the network see this guide.

Re: Zoom HUD via Parallels?

PostPosted: Mon Nov 17, 2014 11:51 am
by TheST1G
Thanks. One more question. What are the minimum system requirements for running PT4 on Windows? I can't find it on your products page?

Re: Zoom HUD via Parallels?

PostPosted: Mon Nov 17, 2014 12:07 pm
by kraada
You can find our system requirements here.