1/2 pot CB w/ FD, pot sized CB w/ TPTK, etc.

[dutch81]

How can I make this? If someone has already found a way to record sizes of bets and cbets along w/ the showdown hands, could you please post? I have no experience whatsoever w/ making notes. Thank you.

[kraada]

The filters for bet sizing are in Actions & Opportunity -> Street -> Bet Sizing. You'll want to make a range though otherwise you'll only get exactly the bet amount you want and for odd sized pots that size may not make sense. The filters for showdown hands are in Hand Values -> Made Hands.

[dutch81]

Man, that's a lot more confusing than I thought. Could you give me an example so I could copy and adjust from there?

Could you show me how "c-bets X pot w/ sets" would like?

Thank you.

[kraada]

Take a look at the built in note:
101 - Donks Flop With Top Pair or Better
to see how the hand strength filters combine.

And take a look at:
202 - Called Two Half Pot or Greater Barrels w/ Draw (FD/OESD)

To see how you can look at pot size related considerations.

[dutch81]

Is it possible for you to give me an example of say, how to make a filter for "c-bets 1/2 pot with X"?

That way I can just replace 1/2 pot with 2/3, pot, etc. That would allow the note to list all sizes of bets and list the hand strength (sets, OESD, TPTK, etc.)

I just have no clue how to start making this type of filter.

Making a filter based on open-limp or open-limp re-raising range was much easier than this.

[kraada]

Actions & Opportunities -> Flop -> Bets -> Continuation Bet
and
Actions & Opportunities -> Flop -> Bet Sizing -> Flop Bet Size between 45 and 55 Percent of Pot
and
Hand Values -> Made Hands -> Whatever made hand strength you want.

[dutch81]

Is this ok?

For some reason, I can't make the filter active. Tried saving and clicking OK to no avail... Any suggestions? Reopening PT4 didn't do it either. Thank you for your patience and willingness to teach us.

[kraada]

You're going to want to OR those filters together -- you can't have both a high card hand and a one pair hand and a two pair hand etc.

[dutch81]

Do you mean organize by saying "OR"?

Not sure I follow... each filter can only have 1 high card, 2 pair or flush?

So I would have to make one filter for 1/2 pot sized CB's specifically for high card, and another for 2 pair, another for flushes?

Is there a way I can copy this filter and save it so all I have to do is adjust the values and edit the name.
Forgive me if I'm way off base, had PT for years but never made anything custom except my HUD.

Thanks again.

[kraada]

The entire filter set has to match a hand for the hand to be given the note. There is no hand such that the player in that hand has both one pair and two pair on the same street.

For how to use the Or Selected button, see here.