Color code stat by position possible

[Tinman9956]

I would like to color code my stats in the session reports. I colored my RFI stat but it colors every position with color ranges I set for the BTN. Is it possible to set each position with different colors? Here are some screen shot of what stats I have found, and is it possible to modify them to do what I want. Stats I would like to color code by position are VPIP, PFR, 3Bet, steal, steal success. Thanks for your time.

[WhiteRider]

There is a known issue with custom stats in that report, although I'm not sure it will affect your exact issue as I would expect that issue to mean that cached custom stats show the same value for each position. I think that may not be happening because you're using built-in columns, but I suspect this could be related.

Another possible cause is that the way you have set up your middle color range will not work. If you want to check for a range of values you need to write it as:

#Raise First In# > 39 and #Raise First In# < 46

However, rules are applied in order so if you keep that order you do not actually need the second part and can just use:

#Raise First In# > 39

..because a value over 46 would have already met the first condition.

I do not think you need to use a custom stat here at all - you can add color ranges to built-in stats, and that may mean that the issue I mentioned would not affect you.
If you add your color conditions to the built-in stat do you still have the problem?

[Tinman9956]

Thanks for the reply. The thing is when I apply the color ranges, it applies it to all positions. I want to apply different colors to different positions, like set up GTO RFI ranges per position and color code them to see when I deviate from them. The range colors in the screen shot are for the BTN. I would like to apply different ranges and colors to the other positions. Hope that makes sense. Thanks Again. Thanks for the info on the stat set up I changed it as you suggested.

[WhiteRider]

Ah, I see.

You can do that, but it makes the color conditions a little more complicated.
You will need to specify the position value as well as the stat value for each combination.
For example:

#Position# = 5 and #Raise First In# > 46

Position is a numeric value as defined here: (for reference: see the column val_position_type, which is used by the Position stat)
Position Type (SB - 0, BB - 1, EP - 2, MP - 3, CO - 4, BTN - 5)

[Tinman9956]

Perfect just what I was looking for. You Rock, Thanks.